Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Exterior Section: Exterior Panels/Trim
Model Year: 2008 Model: Sequoia Doc ID: RM000003GRT000X
Title: EXTERIOR PANELS / TRIM: FRONT DOOR BELT MOULDING: REMOVAL (2008 Sequoia)

REMOVAL

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure described below is for the LH side.

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:

Use the same procedure as for the RH side DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+ .

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

HINT:

Use the same procedure as for the RH side DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+ .

3. REMOVE FRONT ARMREST BASE UPPER PANEL

HINT:

Use the same procedure as for the RH side DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+ .

4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:

Use the same procedure as for the RH side DOOR / HATCH: FRONT DOOR: DISASSEMBLY (2008 Sequoia)+ .

5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY MIRROR (EXT): OUTER REAR VIEW MIRROR: REMOVAL (2008 Sequoia)+

6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY



(a) Apply protective tape to the door panel in the area around the front door glass outer weatherstrip.

(b) Using a moulding remover, disengage the 5 claws and the clip and remove the front door glass outer weatherstrip.